Coated Cellophane

CelloVet Coated Cellophane for banding congenital liver shunts, are made from pure, regenerated cellulose with a biocompatible coating. This provides the cellophane with improved resilience and handling properties.

The cellophane is supplied non-sterile in a moisture and light resistant bag. Keep out of light and ambient humidity. . 

Sterilize with EtO or autoclave.
Approximate shelf life of 12 months.




How To Sterilize

Autoclaving recommendations for cellophane products are as follows (CelloVet, uncoated & coated):
1. Soak the CelloVet Cellophane in DISTILLED water for 5 minutes,
then gently wrap in open pore gauze and place in pouch for autoclaving.
2. Use an autoclave profile set at 15 minutes at 121 C (250 F). Make sure there are as few items in the autoclave during cycle as possible to prevent moisture collection. 
3. Do not activate a dry cycle. Remove from autoclave and leave to air dry.
4. Use the CelloVet within 12-24 hours of autoclaving. 
Do not flash sterilize.

Ethylene oxide gas sterilization recommendations (CelloVet, uncoated & coated):
1. Use regular cycle. 
2. Use the CelloVet within 1 week of sterilization.

EtO is a low temperature alternative and at the moment is considered the most consistent means of sterilizing the CelloVet cellophane products.
Do not re-sterilize if placed in contact with bodily fluids or used in a patient.
Single use only.
Please test our product for durability and malleability in your sterilizer of choice.





Instructions for Use


Only remove cellophane from packaging when you intend to sterilize it for surgery in the immediate future. When stored properly an approximate shelf life of 6+ months is expected.

1. Remove cellophane strip from packaging it was supplied in and place into a single or double wrapped, self sealing surgical pouch.
You may wish to fold or roll the cellophane into 4 layers at this stage to minimize handling during surgery. Our current recommendations are to roll the cellophane instead of folding.
Do not place multiple pieces of cellophane into individual pouches for sterilizing as they may irrevocably stick together. You may wish to wrap the cellophane in a sterilizable, non-stick material such as gauze to prevent it from sticking to the pouch during autoclaving.

2. Sterilize the CelloVet using your preferred means. Follow instructions for each method below.

3. When in surgery, first ensure that your shunt has been isolated and the surgical site is as dry as possible. Make sure you gloves are clean and dry when handling the cellophane. If you haven't already pre-op, roll or fold the cellophane parallel to its fibers and layer (minimum 4 layers) until 3-5 mm wide or to desired width. Recent experience suggests that when clipping together moist cellophane intra-op, rolling of the cellophane may be better than folding when it comes to cut through.

4. Pass the cellophane around the shunting vessel. Bring CelloVet ends into a side-side apposition (image below). Use at least 4 vessel clips usually Medium or Medium/Large in alternating directions to secure free ends (herringbone pattern of application has been suggested by some clients). Do this gently to limit the risk of cut through. Consider using as large a clip size as possible and ensure there is no upward tension at the base (denoted with arrow) of the CelloVet to reduce the risk of cut through. If attenuation of the vessel is required intra-op, we recommend measuring portal pressures to avoid portal hypertension. Attenuation of the shunt may not be required and is at surgeon's discretion.

5. Trim excess cellophane from free ends. Do not touch shunt site and do not lavage. The CelloVet will become soft quickly, so avoid excessive or unnecessary handling.

These instructions are for application of CelloVet Cellophane Bands around Portosystemic Shunts in Dogs and Cats.
[Updated October 2020]


Brand CelloVet